Perlick HC24BB31L 사용 및 관리
11
perlick.com
perlick residential installation manual
Problem
Cause
Solution
Compartments are warmer than usual
Control preset is set to warm
• Lower the setpoint temperature. Refer
to changing the set point for the specific
model
Light is staying on
• Turn the manual light switch off.
Condenser is dirty or obstructed
• Clean the condenser and clear
obstruction.
The door is open or has been opened more
frequently lately.
frequently lately.
• Wait 24 hours and recheck the
temperature.
Internal louvers and/or the fan guard is
obstructed.
obstructed.
• Reset the preset temperature if necessary
– refer to page 5 and 6 of this guide.
• Make sure the louvers and/or the fan are
not obstructed.
Warm product product was recently placed in
the cabinet.
the cabinet.
• Wait 24 hours for product to chill, then
recheck the temperature.
System runs for a long period of time.
Condenser is dirty or obstructed.
• Clean the condenser and clear the
obstruction.
Door was kept open for a long time or was
opened more frequently, or warm product
was recently placed in the cabinet.
opened more frequently, or warm product
was recently placed in the cabinet.
• Wait 24 hours and recheck temperature.
Hot day and warm room temperature
• Normal for the system to run more
frequently.
Condensation forms inside the compartments High humidity and/or frequent door opening
• Normal operation
Door is not closing and sealing properly
• Make sure the door is closing properly.
Check the door seal and replace if
necessary.
• If condensation persists, contact Perlick
Technical Service at 800-558-5592