Speed Queen ADEE9B 설치 설명서

Installation

Before You Start

Supplies

For most installations, the basic supplies you will need are:

DRY2586N_SVG

1.   Wrench
2.   1/4 inch Driver
3.   Screwdrivers
4.   Level
5.   Gloves
6.   Teflon Tape
7.   Duct Tape
8.   Safety Glasses

Figure 1

NOTE: This appliance is suitable for use in countries
having a warm, damp climate.

WARNING

Any disassembly requiring the use of tools must be
performed by a suitably qualified service person.

W299

Parts Included

An accessories bag has been shipped inside your dryer. It in-
cludes:

• Installation Instructions
• User’s Guide
• Dryer Rack Reply Card
• Warranty Bond
• Three screws (electric dryers only). Refer to Electric Dryer

Only - Connect Electrical Plug.

Order of Installation Steps

1.   Position and level the dryer.
2.   Connect dryer to exhaust system.
3.   For gas models only, connect the gas supply pipe. Check for

gas leaks.

4.   For electric models only, connect the electrical cord.
5.   Reverse the door, if desired.
6.   Wipe out the inside of the dryer.
7.   Plug in the dryer.
8.   Recheck steps.
9.   Start and run the dryer in a heat setting to verify dryer is heat-

ing.

Position and Level the Dryer

1. Install dryer before washer. This allows room for attaching

exhaust duct.

2. Select a location with a solid floor. Dryers installed in resi-

dential garages must be elevated 18 inches [457 mm] above
the floor.

No other fuel burning appliance should be installed in the same
closet with the dryer.

The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.

The dryer needs sufficient clearance and an adequate air supply
for proper operation and ventilation, and for easier installation
and servicing. (Minimum clearances are shown in Figure 3 ).
3. Place the dryer in position, and adjust the legs until the dryer

is level from side to side and front to back. Leveling legs can
be adjusted from inside the dryer with a 1/4 in. driver.

4. All four legs must rest firmly on the floor so the weight of the

dryer is evenly distributed. The dryer must not rock.

Installation

Part No. 514320R1