Danby DPA085B1GB 사용자 매뉴얼
Care and Maintenance
AIR FILTER
IMPORTANT
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, paint thinner or other chemicals to clean
2) Do not use gasoline, paint thinner or other chemicals to clean
the unit.
3) Do not wash the unit directly under a tap or using a hose.
It may cause electrical damage.
4) If the power cord is damaged, contact the service depot
immediately.
Clean the air filter at least once every two weeks. Accumulation of dust
will hinder fan operation.
will hinder fan operation.
REMOVAL
This unit has two filters. Grasp the upper filter tab and take it
out in the direction of the arrow as shown in Fig.25. Remove the lower fil-
ter by grasping the filter tab and removing it in the direction of the arrow
as shown in Fig.25.
This unit has two filters. Grasp the upper filter tab and take it
out in the direction of the arrow as shown in Fig.25. Remove the lower fil-
ter by grasping the filter tab and removing it in the direction of the arrow
as shown in Fig.25.
CLEANING
Wash the air filter by submerging it gently in warm water (about 40°C /
104 °F) with a neutral detergent. Rinse the filter and dry it in a shady
place.
Wash the air filter by submerging it gently in warm water (about 40°C /
104 °F) with a neutral detergent. Rinse the filter and dry it in a shady
place.
REPLACING
Install the upper and lower air filters after cleaning. Reinsert them in the
direction of the arrow. (see Fig.26). *Filters should be dry before installing.
Install the upper and lower air filters after cleaning. Reinsert them in the
direction of the arrow. (see Fig.26). *Filters should be dry before installing.
NOTE: The upper (lower) grills and the upper (lower)air filters are
connected and can be separated.
connected and can be separated.
UNIT ENCLOSURE
Use a lint-free cloth soaked with neutral detergent to clean the unit
enclosure. Finish by wiping with a dry clean cloth.
enclosure. Finish by wiping with a dry clean cloth.
LONG TERM
STORAGE
STORAGE
• Remove the rubber plug at the back of the unit and attach a hose to
the drain outlet. Place the open end of the hose directly over the drain
area in your basement floor (See page 14).
area in your basement floor (See page 14).
• Remove the plug from the bottom drain outlet, all the water in the bottom
tray will drain out (See page 14).
• Keep the appliance running on FAN mode for half a day in a warm room
to dry the appliance inside and prevent mold formation.
• Turn off the appliance and unplug it, wrap the cord and bundle it with tape.
• Remove the batteries from the remote controller.
• Clean the air filter and reinstall it.
• Remove the batteries from the remote controller.
• Clean the air filter and reinstall it.
Upper filter
(Take out)
(Take out)
Lower filter
(Take out)
(Take out)
Fig.25
Upper filter
(Install)
(Install)
Lower filter
(Install)
(Install)
Fig.26
15