Vigo Industries VG15327 사양 시트
4
TROUBLESHOOTING
PROBLEM
POTENTIAL CAUSE
CORRECTIVE ACTION
1 - Leaks from handle
2 - Insufficient flow rate
3 - Leak at connection points
4 - Loose faucet body
PARTS LIST -
For any parts needed but not shown, please contact Vigo Technical Support
PART
TOLL FREE: (866) 591 - 7792
E-Mail: techmail@vigoindustries.com
www.vigoindustries.com
PART #
FINISH
SUPPLY DATE INDICATOR (INTERNAL USE ONLY)
1.A - Cartridge unseated
1.B - Cartridge defective
1.B - Cartridge defective
2.A - Dirty aerator
2.B - Clog in supply hose / line
2.B - Clog in supply hose / line
3.A - Sprayer hose not tight
3.B - Flexible hose leaking at body or connection point
3.B - Flexible hose leaking at body or connection point
4. - Metal nut became loose
3.A - Remove sprayer and check integrity of the black washer.
Make sure the washer is seated properly and retighten.
Make sure the washer is seated properly and retighten.
2.B - Remove sprayer or supply line and flush lines
2.A - Remove and soak / clean with a non abrasive agent (i.e.
vinegar).
vinegar).
1.B - Contact Vigo Technical Support for replacement.
1.A - Remove cartridge from housing, wash thoroughly with hot
water and reseat in housing.
3.B - Tighten hoses. If this does not resolve the issue, remove
the flexible hose and rethread, checking to make sure the
connection is secure. Make sure to use pipe tape.
the flexible hose and rethread, checking to make sure the
connection is secure. Make sure to use pipe tape.
4. - From under the counter, use an adjustable wrench and
tighten the metal nut to the hollow pipe. Make sure the faucet is
perpendicular to the counter.
tighten the metal nut to the hollow pipe. Make sure the faucet is
perpendicular to the counter.
W
ST
78025
Sprayer
Handle Set Screw
Sedal Cartridge
Metal braided Hose
Handle Lever
Pull out Hose (black nylon)
74018
-
W
ST
W
78026A
78026C
W
ST
74040
-
W
74020
W
-
Handle
78026B
W
ST
NSF / ANSI 61