Zephyr ZROM90CS 사용자 매뉴얼

1.  Measure from range top to hood bottom and mark line A.  (26” 

minimum from range top) .

2.  Plum and mark center line.

3.  Mark hood height line B. (12-3/16” from line A)

4.  Mark mounting spread from C/L. (12-5/8” on line B) 

5.  Fasten (2) M4 x 1-1/2” screws into studs on line B but do 

not tighten all the way.  Note: Wood blocking may need 
to be added behind the drywall if no studs are present.
Wall anchors may also be used but check local codes 
for compliance. Failure to use suitable wall anchors 
and screws to hold the weight of the hood could result 
in personal injury or damage to the cooking surface or 
counter. 

6.  Remove the (2) aluminum mesh fi lters.

7.  Hang hood onto the mounting screws and hand tighten each 

screw. (Fig A) 

8.  Center and attach duct cover mounting bracket to wall just 

below the ceiling or soffi t using (2) M4 x 1” screws.

9.   Install electrical and duct work.  Seal duct work with aluminum 

duct tape.

10. Power up hood and check for leaks around duct tape.

11. Place telescopic duct covers onto hood and extend inner (top) 

duct cover upwards and secure to duct cover bracket using (2) 
M3.5 x 8 screws. Reinstall mesh fi lters.

   * If using hood in recirculating mode you must secure the air 

diverter plate onto wall before installing duct work and duct 
covers.  You will also need to install charcoal fi lters and 
brackets. Turn to page 10 for more details.

26” min.

12-

5/8

”

12-

3/16

”

Cable Lock

A cable locking connector (not supplied) might 
be required by local codes.  Check with local 
requirements and codes, purchase and install 
appropriate connector if necessary.