Zephyr ZSPE48AS 사용자 매뉴얼

1.  Measure from range top to hood bottom and mark line A.  

(26” minimum from range top).

2.  Plum and mark center line.

3.  Mark mounting height line B. (12-1/8” from line A)

4.  Mark mounting spread from C/L on line B 14-15/16” 

5.  Fasten (2) M4 x 1-1/2” screws into studs on line B.  Do not 

fasten screws all the way. Note: wood blocking may need 
to be added behind the drywall if no studs are present.
Wall anchors may also be used but check local codes 
for compliance. Failure to use suitable wall anchors 
and screws to hold the weight of the hood could result 
in personal injury or damage to cooking surface or 
counter.

6.   Install 10” round duct collar with backdraft damper to top of 

hood by (4) M4x8 fl at screws. 

7.  Hang hood onto screws and hand tighten. (FIG. A #1)   Use 

the last M4 x 1-1/2” screws to further secure the hood to the 
wall from inside the hood. (FIG. A #2)

8.   Center and attach duct cover bracket to wall below ceiling 

or soffi t using (2) M4 x 1 1/2” screws.

9.    Install electrical.

10.  Install duct work and duct tape.

11.  Power up hood and check for leaks around duct tape.

12.  Place telescopic duct covers onto hood and extend inner     

 (top) duct cover upwards and secure to duct cover bracket
  using (2) M4x8” screws.                                       

A

C

B

C/L

12-1/8"

1-3/8"

14-15/16"

13"

C/L

26" min

2

1

Duct Cover Bracket

14-15/16"