Maytag UXT2030AD 사용자 매뉴얼

■

Depending on your model, determine which venting method 
to use: roof or wall. 

■

It is recommended that the vent system be installed before 
the range hood is installed. Go to “Venting System” in the 
“Installation Requirements” section if you need assistance.

■

Before making cutouts, make sure there is proper clearance 
within the ceiling or wall for the vent system.

1. Disconnect power

2. Mark Hole Locations 

Align the exterior edge of the mounting brackets with the exterior 
edges of the upper cabinet.

IMPORTANT: The brackets should touch the upper cabinet.

With a pencil, mark the upper holes on the brackets.

3. Install Brackets 

■

Using a #2 Phillips screwdriver, install the drywall anchors. 

■

Using #8-18 x 

1" (4.2 x 25 mm) flat-head #2 Phillips screws, 

install the mounting brackets using the upper holes.

NOTE: For installations to a surface other than drywall, it is 
recommended that a qualified contractor determine the 
anchoring method.

4. Prepare Range Hood

■

Set the range hood on its back on a covered surface.

■

Using a #2 Phillips screwdriver, remove the 7" (17.8 cm) 
round vent mounting plate attached with 3.5 x 9.5 mm 
screws. 

■

Using a #2 Phillips screwdriver, remove the electrical box 
cover.

■

Using a flat-blade screwdriver, remove the appropriate power 
supply knockout.