Amana NTW4701BQ 사용자 매뉴얼

Select the setting most suitable for your load. Ex small or 

Small (depending on model) will add a low amount of water 

for smaller loads and Large will add the most amount of 

water for large or bulky loads. Items need to move freely. 

Tightly packing can lead to poor cleaning performance, and 

may increase wrinkling and tangling.

Temperature senses and maintains uniform water  

temperatures by regulating incoming hot and cold water. 
Select a wash temperature based on the type of fabric  

and soils being washed. For best results and following  

the garment label instructions, use the warmest wash  

water safe for your fabric.  

 

■

 On some models and cycles, warm and hot water may  

be cooler than your previous washer.

 

■

Even in a cold and cool water wash, some warm  

water may be added to the washer to maintain  

a minimum temperature.   

This option can be added to most cycles and must be set 

to YES if using fabric softener during a cycle. It ensures that 

fabric softener is added at the correct time in the rinse for  

even distribution.

Use the Wash Cycle knob to select cycles on your washer. 

Knob does not advance during the progress of the cycle, see 

cycle status lights for each stage of the process. See “Cycle 

Guide” for detailed descriptions of cycles.  

Press to start the selected cycle; press again to pause  

the cycle and unlock the lid. 
NOTE: If the washer is spinning, it may take several  

minutes to unlock the lid. Press and hold for 3 seconds  

to cancel a cycle.

The Cycle Status Lights show the progress of a cycle. At 

each stage of the process, you may notice sounds or pauses 

that are different from traditional washers.

When the START/Pause/Unlock Lid button is pressed, 

the washer will fill to the selected water level. If the lid is 

closed when the machine is done filling the lid will lock 

and the machine will begin operation. 
If the lid is open when the water stops entering the 

machine, the cycle will not begin until the lid has been 

closed and the START/Pause/Unlock Lid button is 

pressed. If the cycle has not been started within  

10 minutes of the water filling the washer, the washer  

will pump out the water. 

Not all features and options are available on all models.  

Appearance may vary.