Amana NTW4701BQ 사용자 매뉴얼

Wash Temperature
Hot
Some cold water is added to save 

energy. This will be cooler than 

your hot water heater setting.

Warm
Some cold water will be added, so 

this will be cooler than what your 

previous washer provided.

Cool
Warm water may be added to  

assist in soil removal and to help 

dissolve detergents.

Cold
This is the temperature from your 

faucet. If your tap cold water is  

very cold, warm water may be 

added to assist in soil removal  

and help dissolve detergent.

Whites and pastels
Durable garments
Heavy soils

Bright colors 
Moderate to light soils

 

Colors that bleed  

or fade 
Light soils

Dark colors that  

bleed or fade 
Light soils

Select the Load Size setting most suitable for your load. Small 

will add a low amount of water for smaller loads and Large  

will add the most amount of water for large or bulky loads. 

Garments need to move freely.

Once you select a cycle, select the desired temperature by 

turning the Wash Temperature knob to the appropriate setting 

based on your load. All rinses are cold.
NOTE: Always read and follow fabric care label instructions to 

avoid damage to your garments.

If you are using fabric softener, be sure to set the Fabric 

Softener option knob to YES.

Press the START/Pause/Unlock Lid button to start the wash 

cycle. When the cycle has finished, the CYCLE COMPLETE 

indicator will light. Promptly remove garments after cycle has 

completed to avoid odor, reduce wrinkling, and rusting of 

metal hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock Lid; the lid will unlock once  

the washer movement has stopped. This may take several 

minutes if the load was spinning at high speed. Then close  

lid and press START/Pause/Unlock Lid again to restart  

the cycle.
If lid is left open for more than 10 minutes, the water will  

pump out automatically. 

Replace inlet hoses after 5 years of use to reduce the risk 

of hose failure. Periodically inspect and replace inlet hoses 

if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of 

replacement on the label with a permanent marker.
NOTE: This washer does not include inlet hoses. See the 

“Installation Instructions” for more information.