Frigidaire FGEC3045PS 사용자 매뉴얼

BeFore setting surFace controls

surface cooking settings

Use the chart to determine the correct setting for the

type of food you are preparing.
note: The size and type of cookware used will influence

the setting needed for best cooking results.

recommended setting for surface element

setting

type of cooking

HIGH (HI)

Start most foods; bring water to a boil

and pan broiling.

MEDIUM HIGH

(8-10)

Continue a rapid boil; frying, deep fat

frying.

MEDIUM (6)

Maintain a slow boil; thicken sauces

and gravies; steaming vegetables.

MEDIUM LOW

(2 - 4)

Keep foods cooking; poaching and

stewing.

LOW (LO)

Keep warm, melting and simmering.



note

Radiant elements have a limiter that allows the element

to cycle on and off, even at the HI setting. This helps to

prevent damage to the ceramic smooth top. Cycling at

the HI setting is normal and can occur if the cookware

is too small for the radiant element or if the cookware

bottom is not flat.

caution

do not place plastic items such as salt and pepper

shakers, spoon holders or plastic wrappings on

cooktop when it is in use. These items could melt or

ignite. Potholders, towels or wooden spoons could catch

fire if placed too close to the surface elements.

caution

do not allow aluminum foil, or anY material that

can melt to make contact with the ceramic glass

cooktop. If these items melt on the cooktop they will

damage the ceramic cooktop.

The radiant surface elements are located on the 36”

cooktop as follows:

model c:

• Two small 6 inch radiant element located one at the left

rear and the other one at the right rear position.

• One dual 6 or 9 inch radiant element located at the

right front position.

• One 12 inch radiant element located at the left front

position.

• One 7 inch radiant element located at center rear

position.

model c

model d

model d:

• Two small 6 inch radiant element located one at the left

rear and the other one at the right rear position.

• One dual 6 or 9 inch radiant element located at the

right front position.

• One dual 9 or 12 inch radiant element located at the

left front position.

• One 7 inch radiant element located at center rear

position.



note

Due to the high intensity of heat generated by the

surface elements, the glass surface will turn green

when the element will be turned off. This phenomenon

is normal and the glass will come back to its original

white color after it has completely cooled down. (White

glass cooktops only).