Maytag MEC7430B 설치 설명서

IMPORTANT: Use the 3-wire cable from power supply where 
local codes permit connecting the frame-ground conductor to 
the neutral (white) junction box wire:

1. Disconnect power

2. Remove junction box cover, if present.

3. Connect the flexible cable conduit from the cooktop to the 

junction box using a UL listed or CSA approved conduit 
connector.

4. Tighten screws on conduit connector if present.

5. Connect the two black wires together using the UL listed wire 

connectors.

6. Connect the two red wires together using the UL listed wire 

connectors.

7. Connect the green or bare cooktop cable wires to the white 

(neutral) wire in the junction box using the UL listed wire 
connectors.

8. Install junction box cover.

9. Reconnect power.

NOTE: This section applies only if you are using clamping 
brackets.

1. Place the 2

¹⁄₂" (6.4 cm) clamping screws into the outermost 

hole in the clamping bracket.

2. Use a screwdriver to tighten the screws against the 

countertop. Do not overtighten.

1. Check that all parts are now installed. If there is an extra part, 

go back through the steps to see which step was skipped.

2. Check that you have all your tools.

3. Dispose of/recycle all packaging materials.

4. Use a mild solution of liquid household cleaner and warm 

water to clean cooktop before use. Dry thoroughly with a soft 
cloth. For more information, see the “Cooktop Care” section 
of the Use and Care Guide.

5. Read the “Cooktop Use” section in the cooktop Use and 

Care Guide.

6. Reconnect power.

NOTE: If the cooktop does not work after turning on the power, 
check that a circuit breaker has not tripped or a household fuse 
has not blown. See “Troubleshooting” section in the Use and 
Care Guide for further information.

Please reference the “Assistance or Service” section of the Use 
and Care Guide or contact the dealer from whom you purchased 
your cooktop.

H

B

C

D

E

F

G

I

A

¹⁄₂

A

B

C

D

E

F

G