Fagor 60CFG30B 설치 가이드
7
2/ INSTALLING YOUR APPLIANCE
INSTALL THE DUCTWORK
1.
Where the ductwork will run between the hood and the outside.
2.
A straight, short duct run will allow the hood to perform most efficiently.
3.
Install the Aluminum Flex duct on the vent towards
hood location.
hood location.
INSTALL MOUNTING BRACKETS
1.
After evaluating the height of the hood, place the
hook center over installation location. Drill 3 holes of
Ø8mm on a suitable place to fix the mounting
brackets.
hook center over installation location. Drill 3 holes of
Ø8mm on a suitable place to fix the mounting
brackets.
2.
Put the drywall anchors into the holes and fix the
mounting screws (4x40mm) into the anchors, and
install the hook on the wall as shown.
mounting screws (4x40mm) into the anchors, and
install the hook on the wall as shown.
INSTALL DUCT FIXING SUPPORT
1.
Calculate the final height of the U-shaped section, drill 2 holes of Ø8mm on a suitable
place in line with the slidery duct fixing support.
place in line with the slidery duct fixing support.
2.
Put the drywall anchors into the holes and fix the mounting screws (4x40mm) into the
anchors, and install the hook on the wall as shown.
anchors, and install the hook on the wall as shown.
NON-DUCTED RECIRCULATION FILTER INSTALLATION
1
Purchase a non-ducted recirculation filter from your dealer.
(The non-duct
recirculation filter is optional, and bought separately
)
2
Install the filter by rotating it onto the
brackets which are on both sides of
the motor.
brackets which are on both sides of
the motor.
EN