Maytag MVWC215EW 사용 및 관리

The Cycle Status Lights show the progress of a cycle. At 

each stage of the process, you may notice sounds or  

pauses that are different from traditional washers.
 SENSING/FILL
  Once you close the lid and start a cycle, the washer will 

begin filling with the initial amount of water. This will take 

approximately 2-3 minutes and the lid will be unlocked at 

this time. Then the lid must be closed. 

  If the lid is open when the water stops entering the 

washer, the cycle will not continue until the lid has been 

closed and the START/Pause button is pressed. If the 

cycle has not been continued within 10 minutes of the 

water filling the washer, the washer will pump out the 

water. If the lid is closed, it will then lock and the sensing 

process begins and additional water will be added, if 

required. You will hear the motor turn the basket in short 

pulses to thoroughly wet the load.

  WASH 
  You will hear the motor and agitator moving the load. 

During the first stage of the sensing/wash cycle, water 

will partially fill the washer and then begin to move the 

load. It is normal to have the sensing light on during this 

stage. You will hear the agitator rotate, followed by a 

several second pause. This process will repeat for several 

minutes, allowing the entire load to become saturated. 

The lower water level combined with HE detergent at this 

stage allows for concentrated cleaning. Concentrated 

cleaning delivers the detergent directly to the soils. It is 

normal for the load to be above the water line during this 

stage. At the beginning of the second stage, the washer 

will add water to the correct level based on the load size. 

You will hear the agitator move quicker during this stage 

of the wash cycle. The motor sounds may change at 

different stages in the wash cycle.  

You will hear sounds similar to the wash cycle as the washer 

rinses and moves the load. For cycles that use the Extra 

Rinse option, you will hear sounds similar to the wash cycle 

as the washers rinses and moves the load.

 SPIN
  The washer spins the load at increasing speeds for  

proper water removal, based on the selected cycle  

and spin speed. 

 DONE
  Once the cycle is complete, this light will come on.  

Remove the load promptly for best results. 

  LID LOCKED 

To allow for higher spin speeds, the lid will lock and  

the Lid Locked light will turn on. When this light is lit,  

the lid is locked and cannot be opened. When this  

light is blinking, the washer is paused. When this light  

is off, the lid can be opened.

 

If you need to open the lid, press  

START/Pause. The lid will  

unlock once the washer movement  

has stopped. This may take several  

minutes if the load was spinning at  

high speed. Press START/Pause  

again to resume the cycle.

  NOTE: If the START/Pause button is held for more than  

3 seconds, the cycle will cancel and the washer will drain.