Dacor IVS1 설치 가이드
Page 5
Step 3
Installing the IVS
Mount the IVS using screws (supplied by others) which are installed through the finish trim into the hood liner material. For approximate hole
locations refer to figures 4 and 5.
Step 4
Verifying Proper Operation
1. Turn on the power supply at the circuit breaker.
2. Turn ventilator control on. Adjust the blower speed and test for affective draw.
3. Turn on the variable control light switch and verify lights operate correctly.
NOTE:
If the power pack does not operate properly, follow these troubleshooting steps:
1. Verify that power is being supplied to the power pack.
2. Check the electrical connections to ensure that the installation has been completed correctly.
3. Repeat the above tests.
4. If the appliance still does not work, contact an authorized DACOR service company at
(800) 772-7778, or at www.dacor.com. Do not attempt to repair the appliance yourself.
5. DACOR is not responsible for service required to correct a faulty installation.
STEP 2
Electrical Connection
GRN
WHT
BLK
L1
N1
Gnd
L2
N2
Gnd
L2
N2
Gnd
GRN
WHT
BLK
GRN
WHT
120VAC, 60Hz, 15A
Supply power from
dedicated circuit breaker
BLK
GRN
WHT
BLK
IVS
ILB
L1
N1
Gnd
L2
N2
Gnd
L2
N2
Gnd
GRN
WHT
BLK
L2
N2
Gnd
GRN
WHT
120VAC, 60Hz, 15A
Supply power from
dedicated circuit breaker
BLK
GRN
WHT
BLK
GRN
WHT
BLK
GRN
WHT
BLK
IVSR
ILB
REMP
J-BOX
L1
N1
Gnd
L2
N2
Gnd
L2
N2
Gnd
GRN
WHT
120VAC, 60Hz, 15A
Supply power from
dedicated circuit breaker
BLK
GRN
WHT
BLK
GRN
WHT
BLK
IVSR
REMP
Figure 9:
IVSR with ILB Wiring Diagram
Figure 10:
IVSR with REMP Wiring Diagram
Figure 11:
IVSR with ILB and REMP Wiring Diagram