Dacor DHW361 설치 가이드

Installation Instructions

4.  Carefully put the chimney over the top of the duct 

work extending out of the top of the hood, taking care 

not to scratch the surfaces. Make sure the wiring is 

tucked in behind the chimney.

5.  Move the chimney up toward the ceiling. Line up the 

holes on the side of the chimney, above the vents, 

with the holes on the side of the chimney mounting 

bracket.

6.  Attach the sides of the chimney to the bracket using 

two sheet metal screws, one on each side.

7.  Carefully, slide the bottom portion of the chimney 

down until it rests on the top of the range hood.

Verifying Proper Operation

1.  Reinstall the range hood filter(s) before operation.
2.  Make sure power is switched on at the circuit breaker 

panel or fuse box.

3.  If the control panel is not lit, remove the filter(s) and 

turn on the main power switch located behind the 

filters on the underside of the hood. Replace the 

filter(s).

4.  Touch the light key. Verify that all the lights come on.
5.  Touch the light key again to turn the lights off.
6.  Touch the blower “+” key once and release. Verify 

that one light is showing on the blower speed indica-

tor and that the blower is on at low speed.

7.  Touch and release the blower “+” repeatedly, three 

times. Verify that with each touch of the key the num-

ber of lights on the speed indicator increases and that 

the blower speed increases accordingly.

8.  Touch and hold the blower “-” key until the blower 

turns off.

If the hood fails to operate properly:

 

■ Verify that power is supplied to the hood.

 

■ Check the electrical connections to ensure that the 

installation has been completed correctly.

 

■ Repeat the above test.

 

■ If the hood still does not work, contact Dacor 

Distinctive Service at (800) 793-0093 ex. 2822. Do 

not attempt to repair the appliance yourself. If you 

need service, be sure to have the model and serial 

numbers available when you call. See the inside 

cover for location.

Do not attempt to repair the appliance yourself. Dacor 

is not responsible for the cost of correcting problems 

caused by a faulty installation.

Installation Checklist

•  To ensure a safe and proper installation, the follow-

ing checklist should be completed by the installer 

to ensure that no part of the installation has been 

overlooked.

•  Proper installation is the responsibility of the home-

owner. The importance of proper installation of your 

Dacor range hood cannot be overemphasized.

 

□

Is the mounting bracket properly attached to the wall 

according to the instructions on page 6?

 

□

Is the duct work completely installed? Are all joints 

attached with sheet metal screws and wrapped with 

duct tape? See pages 4 and 8?

 

□

Is the range hood wired and grounded according to 

these instructions and in accordance with all appli-

cable electrical codes? See pages 3 and 8.

 

□

Are the filters properly installed according to the use 

and care manual?

 

□

Has proper operation been verified?

 

□

Has the warranty been activated on-line or the war-

ranty card filled out completely and mailed?