Perlick HA24FB32R 사용 및 관리

다운로드
페이지 12
perlick residential installation manual
4
perlick.com
safety
PLEASE READ all instructions completely before attempting 
to install or operate the unit. Take particular note of the 
DANGER,  WARNING and CAUTION information in the 
manual. The information is important for the safe and 
efficient installation, operation and care of your Perlick unit.
DANGER
Indicates a hazard that WILL result in serious injury or 
death if precautions are not followed.
Indicates a hazard MAY cause serious injury or death if 
precautions are not followed.
WARNING
Indicates a hazard where minor injury or product 
damage may occur if precautions are not followed.
CAUTION
oPeration
Master switcH
Signature Series products come equipped with a master 
power switch located behind the louvered toe kick. 
Remove the toe kick to turn power on or off to the unit.
interior ligHt
Door units are equipped with an interior light that 
illuminate when the door is opened. The cabinet also 
comes equipped with a manual light switch for displaying 
the products through a glass door. For Signature Series 
(HP) models, it is located in front of the control cradle. For 
C-Series (HC), ADA-Compliant (HA) and Shallow-Depth 
(HH) models, this is located on the back wall left of the 
light. 
Always ensure that the manual light switch is  in the OFF 
position before closing a solid wood or stainless steel 
door. If manual light switch is left on for an extended 
period of time, it may increase the cabinet temperature, 
and cause the refrigeration system to run harder. 
loading Product
Before storing perishables, turn unit on and allow it to 
operate for a minimum of 24 hours to allow temperatures 
to stabilize.
When loading items into the unit, do not block internal 
louvers and fan guard openings or performance will be 
decreased.
cHecking Product teMPerature
1). To accurately check the temperature of product stored 
in the refrigerated compartment, insert an accurate 
thermometer into a plastic unbreakable bottle, partially 
filled with water. Tighten bottle cap securely.
2). Place the bottle in the desired area for 24 hours. Refrain 
from opening the unit during the testing period. After 
24 hours, check the temperature of the water. Adjust the 
temperature accordingly using the following procedures:
digital teMPerature control
Signature Series Models
Perlick Signature Series, C-Series, Shallow-Depth Series 
and ADA Compliant freezer units come standard with 
state-of-the-art digital control. Please note there are two 
sets of instructions; one for 24” Signature Series Dual-Zone 
models, and another set for 15”, 24” Single-Zone, and 
48” Signature Series, C-Series, Shallow-Depth and ADA-
Complient Freezer models.
Programming Button Definitions:
Figure 1.  Digital Temperature Controller
SET button
DEFROST button (melting snowflake)
UP arrow
DOWN arrow
ON/OFF button