Maytag MED7500YW 사용자 매뉴얼

If dryer is not level, prop up using a wood block, use wrench  

to adjust legs up or down, and check again for levelness. 

Once dryer is level, make sure all four legs are snug against 

the floor and dryer does not rock.

Place 

level here

       Not Level 

            

LEVEL                    Not Level

Check levelness of dryer from  

side to side. Repeat from front to back. 
NOTE: The dryer must be level for the moisture sensing system 

to operate correctly.

q

  Check that all parts are now installed. If there is an extra  

 

part, go back through steps to see what was skipped.

q

  Check that you have all of your tools.

q

  Dispose of/recycle all packaging materials.

q

  Check dryer’s final location. Be sure vent is not crushed  

 

or kinked.

q

  Check that dryer is level. See “Level Dryer”.

q

  Remove film on console and any tape remaining on dryer.

q

  Wipe dryer drum interior thoroughly with a damp cloth to    

 

remove any dust.

q

  Read “Using Your Dryer.” 

q

  For power supply cord installation, plug into a grounded  

 

outlet. For direct wire installation, turn on power.

q

   Set the dryer on a full heat cycle (not an air cycle) for  

20 minutes and start the dryer.

      If dryer will not start, check the following:

•  Controls are set in a running or “On” position.

•  Start button has been pushed firmly.

•  Dryer is plugged into an outlet and/or electrical

   supply.

•  Household fuse is intact and tight, or circuit breaker  

 

  has not tripped.

•  Dryer door is closed.

NOTE: You may notice an odor when dryer is first heated.  

This odor is common when heating element is first used.  

The odor will go away.