Maytag MED7500YW 사용자 매뉴얼

Gather the required tools and parts before starting installation.

Flat-blade screwdriver

Wood block

Adjustable wrench that 

opens to 1" (25 mm) or 

hex-head socket wrench 

Wire stripper (direct wire 

installations)

Tin snips (new vent 

installations)

1/4" (7 mm) nut driver  

(recommended)

 Level

Caulking gun and  

compound (for installing 

new exhaust vent)

Coupling

(Not supplied with dryer)

Parts package is located in dryer drum. Check that all parts  

are included.
NOTE: Do not use leveling legs supplied if installing with  

a pedestal or a stack kit.

Use a UL listed power supply cord kit marked for use with  

clothes dryers. The kit should contain:
n

  A UL listed 30-amp power supply cord, rated 120/240 volt  

minimum. The cord should be type SRD or SRDT and be  

at least 4 ft. (1.22 m) long. The wires that connect to  

the dryer must end in ring terminals or spade terminals  

with upturned ends.

n

 A UL listed strain relief.

Torx

®

 T20 screwdriver 

® TORX is a registered trademark of Saturn Fasteners, Inc. 

(Not supplied with dryer) 

Vent clamps
Vent elbows and ductwork
Additional parts may be required, depending on your  

installation. Check local codes. Check existing electrical  

supply and venting. Read “Electrical Requirements” and  

“Venting Requirements” before purchasing parts.

You may order a pedestal  

separately for this dryer. This  

pedestal will add about 12"  

(305 mm) to the height of your unit 

for a total height of approximately 

45" (1.14 m).
To order, call the dealer from 

whom you purchased your dryer 

or refer to the “Assistance or  

Service” section of this manual. 

Ask for Model Number LAB0050PQ.

Stack kit 
Are you planning to stack your washer and dryer? Your dryer is 

shipped with Stack Kit W10178021, which fits Maytag washer 

models starting with MHWC.
If you have any other washer model, call the dealer from whom 

you purchased your dryer or refer to the “Assistance or Service” 

section of this manual.