Summit FFAR10SSTBLOCKER 사용자 설명서

 

 

During the service of your appliance, you can come across some troubles that in 
most cases result from improper handling of the appliance that can easily be 
eliminated. 

 

 

 

•  Check the supply in the outlet socket and make sure the appliance is 

switched on (thermostat in the operating position). 

 

•  The door was frequently opened or it was left open too long. 

•  The door is not properly closed (the door may sag; the gasket may be 

polluted or damaged). 

•  Perhaps you have overloaded the appliance with fresh foods. 
•  The reason may be inadequate ventilation of the compressor and 

condenser (assures adequate air circulation and wipe off the 
condenser). 

 

Ice Formation on the Inner Rear Wall 
As long as the defrost water runs to the channel and through the opening to the 
drain pan on the compressor, automatic defrosting of the appliance is assured.  In 
case the ice formation on the inner back wall is increased (1/8”), ice should be 
manually defrosted. 
Set the thermostat knob to 0 (off) position and leave the door open.  Never use 
electric devices for defrosting and do not scrape the ice or frost layer with sharp 
objects.  After completed defrosting, turn the knob to desired position and close 
the refrigerator door. 
The cause of increased ice formation may be one of the following reasons: 

-  The door does not seal well (clean the gasket if it is contaminated, 

or replace it if it is damaged). 

-  The door was frequently opened or it was left opened for too long. 
-  The food stored in the refrigerator was warm. 
-  The food or dish is touching the inner back wall. 

 

Water is Leaking from the Refrigerator  
In case the discharged water outlet is clogged, the defrost water drips over the 
channel, or water leaks from the refrigerator just clean the clogged opening with a 
plastic straw. Manually defrost the increased ice layer.   
 
 
 
 

Instructions for Use