BlueStar RGTNB364CFTBV2LP 설치 설명서
BACKGUARD
All range tops require a backguard. Most
models have the option of using: an island
trim; 7 inch standard; 17 inch hi-back; 21 inch
high shelf. Heritage Classic models require a
21 inch high shelf for all installations.
If you are using an island trim a six inch
clearance between the back of the range and a
combustible surface is required. If an island
trim is to be used without this six inch clear-
ance the back wall must be non-combustible
and heat resistant material that extends below
the top surface of the range a minimum of six
inches.
All backguards follow the same basic installa-
tion. Using hardware supplied, align the
backguard with the wrap around on each side
All range tops require a backguard. Most
models have the option of using: an island
trim; 7 inch standard; 17 inch hi-back; 21 inch
high shelf. Heritage Classic models require a
21 inch high shelf for all installations.
If you are using an island trim a six inch
clearance between the back of the range and a
combustible surface is required. If an island
trim is to be used without this six inch clear-
ance the back wall must be non-combustible
and heat resistant material that extends below
the top surface of the range a minimum of six
inches.
All backguards follow the same basic installa-
tion. Using hardware supplied, align the
backguard with the wrap around on each side
and slip the tongue into place. A minimum of
six sheet metal screws (more depending on
width) are to be installed, three on each end
and more along the bottom edge.
Remove the two rear ring grate/top grates
from the cooktop surface. Four sheet metal
screws to be installed - down - into the cook-
top support. Two screws are installed on each
end ring grate/top grate position. Replace the
removed grates.
If you are installing a high shelf there is an
additional channel to be installed on each side
first. The back guard then slips over this
channel as you put it into position. This chan-
nel provides extra support for the higher rise
of the 21 inch back.
six sheet metal screws (more depending on
width) are to be installed, three on each end
and more along the bottom edge.
Remove the two rear ring grate/top grates
from the cooktop surface. Four sheet metal
screws to be installed - down - into the cook-
top support. Two screws are installed on each
end ring grate/top grate position. Replace the
removed grates.
If you are installing a high shelf there is an
additional channel to be installed on each side
first. The back guard then slips over this
channel as you put it into position. This chan-
nel provides extra support for the higher rise
of the 21 inch back.
INSTALLATION
RGTNB 2011-REV1