Friedrich IDK 설치 가이드
616-197-01 (10-04)
1.
DRILL A .625" DIAMETER HOLE IN THE BOTTOM OF THE SLEEVE BASE TO THE
DIMENSIONS SHOWN.
DIMENSIONS SHOWN.
2.
APPLY A SILICONE TYPE OF SEALER TO THE OUTSIDE BOTTOM EDGES OF THE
DRAIN PLATE.
DRAIN PLATE.
3.
INSERT THE DRAIN TUBE INTO THE HOLE AND PRESS THE DRAIN PLATE DOWN TO
FORM A WATERTIGHT SEAL AGAINST THE SLEEVE BASE.
FORM A WATERTIGHT SEAL AGAINST THE SLEEVE BASE.
4.
DRILL A .625" DIAMETER HOLE IN THE BOTTOM OF THE BASE PAN AS SHOWN
IN THE ILLUSTRATION. THIS HOLE ALLOWS CONDENSATE TO ENTER THE WALL
SLEEVE WHERE IT TRAVELS TO THE DRAIN KIT FOR DISPOSAL.
IN THE ILLUSTRATION. THIS HOLE ALLOWS CONDENSATE TO ENTER THE WALL
SLEEVE WHERE IT TRAVELS TO THE DRAIN KIT FOR DISPOSAL.
INSTALLATION INSTRUCTIONS
FOR INTERNAL DRAIN KIT
(IDK)
Apply Sealer to
the bottom of
the Drain Plate
the bottom of
the Drain Plate
Wall Sleeve
Sleeve
Base
Dimple
Drill a .625"
diameter
hole in the
bottom of
the basepan
4.75" From
back of
basepan
0.5" In
from edge
Drill a .625"
diameter
hole here