BlueStar PRZIDCB30V2 사용자 매뉴얼

                                   P/N 750301 Page   17 

 

All specifications are subject to change without prior notification 

As part of the installation, protective plas-
tic wrappers on stainless steel surfaces 
should be removed.  These wrappers must 
be removed before operation. 
New appliances are wiped clean with vari-
ous cleaners and solvents to remove visi-
ble signs of dirt, oil and grease before 
leaving the factory.  After installation, 
performance checks and adjustments, the 
appliance should be allowed to heat to 
burn off any such oils from internal parts.  
The presence of such coatings is normal 
as part of the manufacturing process.  The 
ventilation hood should be turned on and 
the area well ventilated to allow fumes to 
escape safely. 
Removable parts should be washed with 
hot soapy water, well rinsed and wiped 
dry.

 

Complete and mail your Performance 
Checklist to validate your warranty.

 

 

Ensure there is nothing on the grilling 
rack. 
Push in and turn the control knob counter 
clockwise approximately halfway to 
―HIGH‖. 
The hot surface igniter will glow brightly, 
gas will flow from the valve and the 
burner will light.  This takes approxi-
mately one minute. 
On a 15-inch charbroiler, there is one 
burner and one control knob.  On a 30-

inch charbroiler, there are two burners and 
two control knobs.  This control knob is 
both a gas valve and an electric switch. 
When the knob is in the "IGN" position 
and after the oven igniter glows a bright 
red, gas is permitted to flow to the burner.   
Adjust the flame to the desired height. 
The oven burner should burn blue with 
"cones" approximately 7/16 inch high. 
After cooking, allow to cool completely. 
Remove the drip pan slowly, discard 
grease and food particles.  Wash with 
warm soapy water, rinse and replace. 
The charbroiler grate is porcelain coated 
and may be washed with hot soapy water 
and a grill brush. 

 
 
GRIDDLES (Add On Option) 

New griddles must be seasoned prior to 
their first use. 
Remove all factory materials and wash the 
griddle plate with hot soapy water.  Rinse 
and dry thoroughly. 
Apply a light coating of unsalted peanut 
oil to the top, sides and front of the grid-
dle plate.  Wipe away any excess oil. 
To light the burner, turn the knob counter 
clockwise to the medium setting. 

7/16"

Charbroiler Burner