Frigidaire FFES3015LS 설치 설명서

7

Where local codes does NOT permit connection of the 

frame grounding conductor to the neutral wire of the 

copper power supply cord (see Figure 4):

1.  Remove the 3 screws at the lower end of the rear 

wire cover, then raise the lower end of the rear 
wire cover (access cover) upward to expose range 
terminal connection block (see figure 2).

2.  Remove the grounding strap from the terminal block 

and from the appliance frame.

3.  Using the nuts supplied with the literature package, 

connect the ground wire (green) of the copper 
power supply cord to the frame of the appliance 
with the ground screw, using the hole in the frame 
where the ground strap was removed (see Figure 4).

4.  Connect the neutral of the copper power supply 

cord to the center silver-colored terminal of the 

terminal block, and connect the other wires to the 

outer terminals. Match wires and terminals by color 

(red wires connected to the right terminal, black 
wires connected to the left terminal).

5.  Lower the terminal cover and replace the 3 screws.

Terminal Block

Silver Colored Terminal 

Red

Wire

Neutral 

(White Wire)

Ground (Bare 

Copper Wire)

To 240 V Receptacle

A User Supplied 

Strain-relief Must 

Be Installed at This 

Location

Black Wire

1 1/8" (2.9cm) 

Dia. Direct 

Connection 

Hole. Punch 

Out Knockout 

for 1 3/8" 

(3.5cm) Dia. 

Cord Kit Hole.

NOTE: Be sure to remove the 

supplied grounding strap.

If local codes permit connection of the frame grounding 

conductor to the neutral wire of the copper power 

supply cord (see Figure 3):

1.  Remove the 3 screws at the lower end of the rear 

wire cover, then bend the lower end of the rear 

wire cover (access cover) upward to expose range 

terminal connection block (see Figure 2).

2.  Using the nuts supplied in the literature package, 

connect the neutral of the copper power supply cord 

to the center silver-colored terminal of the terminal 

block, and connect the other wires to the outer 

terminals. Match wires and terminals by color (red 

wires connected to the right terminal, black wires 

connected to the left terminal) (see figure 3).

3.  Lower the terminal cover and replace the 3 screws.

Silver Colored Terminal

1 1/8" (2.9 cm) Dia. 

Direct Connection 

Hole. Punch Out 

Knockout for 1 3/8" 

(3.5 cm) Dia. Cord 

Kit Hole.

To 240 V 

Receptacle

A User Supplied 

Strain-relief Must 

Be Installed at This 

Location.

Black 

Wire

Terminal

Block

Neutral 

(White Wire)

Grounding

Strap

Red Wire