HP N911a 사용자 매뉴얼
Slide the duplexer into the back of the printer until the unit locks into place. Do not
press the buttons on either side of the duplexer when installing the unit; use them only
for removing the unit from the printer.
press the buttons on either side of the duplexer when installing the unit; use them only
for removing the unit from the printer.
Install Tray 2
NOTE: This feature is available with some models of the printer.
Tray 2 can hold up to 250 sheets of plain paper. For ordering information, see HP
supplies and accessories.
supplies and accessories.
To install Tray 2
1. Unpack the tray, remove the packing tapes and materials, and move the tray to the
prepared location. The surface must be sturdy and level.
2. Turn off the printer, and disconnect the power cord.
3. Set the printer on top of the tray.
CAUTION: Be careful to keep your fingers and hands clear of the bottom of
the printer.
the printer.
4. Connect the power cord and turn on the printer.
5. Enable Tray 2 in the printer driver. For more information, see Turn on accessories
Chapter 1
30
Get started