Maytag MGD4200BG 설치 설명서

Using a TORX

®

 T25 screwdriver, remove the 2 screws 

securing the door strike to the door frame of the dryer. 

Remove the 4 screws above and below the door strike and 

set aside for later use. Rotate the strike 180° and attach to  

the opposite side of dryer door frame, as shown. 

Position the door with the inside of the door facing up. Using 

a Phillips screwdriver, remove the 13 screws securing the 

inner door to the outer door. Lift off the inner door and set 

aside. 

NOTE: There is a small release tab on each side of the door.  

If the inner and outer door do not separate easily, slide a  

credit card, putty knife, or similar flat object between the inner  

and outer doors at the locations shown to release the tab.

Using a TORX T25 screwdriver, remove the 3 TORX screws 

securing the latch plate and the 5 screws holding the hinge 

assembly in place.

Using a TORX T25 screwdriver, reinstall the latch plate and 

hinge assembly on the opposite sides from which they were 

removed.