Maytag MRT711BZDH 사용자 매뉴얼

7. Move the door stop to the opposite side, making sure that the 

hole in the door stop plate is aligned perfectly with the hole for 
the center hinge pin.

8. Using the screw removed in Step 6, fasten the door stop to 

the bottom of the freezer door. 

9. Align the handle with the shoulder screw. Position the handle 

so that the mounting base is flush against the door.

10. Fasten the bottom of the handle to the bottom of the freezer 

door. 

11. Tighten all screws. Set aside the freezer door until the hinges 

and refrigerator door are in place.

1. Remove the screws from the top of the refrigerator door 

handle.

2. Using the 

¹⁄₈" hex key, loosen the setscrew attaching the 

bottom of the handle. Pull the handle away from the door.

3. Remove door hinge hole plug from refrigerator door. Move to 

opposite side hinge hole.

4. Remove and discard the plug covering the hole on the 

opposite side of the door, where the refrigerator door handle 
will be installed.
NOTE: A new door handle hole plug is provided in the 
Reversibility Kit. 

5. Remove the shoulder screw and its washer from the left-hand 

side of the door and fasten it into the hole in the door that was 
behind the plug.

6. Remove the door stop from the bottom of the refrigerator 

door. 

7. Replace the door stop on the opposite side of the refrigerator 

door, making sure that the hole in the door stop plate is 
aligned perfectly with the hole for the bottom hinge pin.   

8. Using the screw removed in Step 6, fasten the door stop to 

the bottom of the refrigerator door.

9. Align the handle with the shoulder screw. Position the handle 

so that the mounting base is flush against the door.   

10. Fasten the top of the refrigerator handle to the top of the 

refrigerator door. 

11. Cover the remaining hole with the hole plug (provided).    
12. Tighten all screws. Set aside refrigerator door until bottom 

hinge is installed on the opposite side of the refrigerator.

1. Remove the screw attaching the hinge pin to the hinge. Turn 

the hinge over so that it is pointing in the opposite direction.

2. Place the plastic spacer beneath the hinge so that it will be 

between the hinge and the cabinet, making sure the holes are 
aligned. 

3. Fasten the top hinge to the opposite side of the cabinet, 

inserting the screws only halfway, so you will be able to 
replace and align the freezer door later.

A

B

A

⁵⁄₁₆

A

B

B

C

A

B

C

A

A

B

C