Frigidaire FPRU19F8RF 사용자 설명서

12

To Remove Light Lens

Press Tabs

in Direction Shown

Mid Level Lighting

The mid level and upper level lighting comes 

on automatically when the door is opened. 

To disconnect power to the unit, unplug 

the unit or switch the breaker that supplies 

power to the unit to the off position. 

Replace the old bulb with a bulb of the 

same wattage.

1. To replace the light bulb, turn the 

temperature control to OFF and unplug 

the electrical cord. 

2. Remove the lens from the lamp housing 

by unsnapping it from the lamp housing 

using your fingers or a screwdriver. Be 

careful not to break the locking tabs on 

the lamp housing. 

3. Replace the old bulb with a bulb of the 

same type and wattage. 

4. To replace the lens, snap one side of the 

lens opening to the tab on the lamp housing. 

Then carefully attach the other side. 

The upper level lighting comes on 

automatically when the door is opened. 

To disconnect power to the unit, unplug 

the unit or switch the breaker that supplies 

power to the unit to the off position. 

Replace the old bulb with a bulb of the 

same wattage.

1. To replace the light bulb, turn the 

temperature control to OFF and unplug 

the electrical cord. 

2. Remove the light shield by pushing in on 

the sides where the two tabs are located 

in the back, then rotate the light shield 

down and out.  

3. Replace the old bulb with a bulb of the 

same type and wattage. 

1. Unplug the power cord.
2. Remove light cover by pushing up and out.
3. Hold the LED cover with one hand and 

pull the connector with the other hand 

while pressing the connector latch.

4. Replace LED light and snap in place 

assuring the light is facing in toward the 

unit (inside fresh food).



LED lights are in series, so if one is bad or
unplugged, several lights may not light up.