AT&T EL52203 사용자 매뉴얼

다운로드
페이지 103
88
Appendix
FCC Part 68 and ACTA
Industry Canada
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause harmful 
interference, and (2) this device must accept any interference received, including interference 
that may cause undesired operation.
Privacy of communications may not be ensured when using this telephone.
The term ‘’IC:‘’ before the certification/registration number only signifies that the Industry 
Canada technical specifications were met.
The Ringer Equivalence Number (REN) for this terminal equipment is 1.0. The REN is an 
indication of the maximum number of devices allowed to be connected to a telephone interface. 
The termination on an interface may consist of any combination of devices subject only to the 
requirement that the sum of the RENs of all the devices does not exceed five.
This product meets the applicable Industry Canada technical specifications.
FCC Part 15
This equipment has been tested and found to comply with the requirements for a Class B digital 
device under Part 15 of the Federal Communications Commission (FCC) rules.
These requirements are intended to provide reasonable protection against harmful interference 
in a residential installation. This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will not 
occur in a particular installation. 
If this equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver  
is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the party responsible for 
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two 
conditions: (1) this device may not cause harmful interference, and (2) this device must accept 
any interference received, including interference that may cause undesired operation. Privacy of 
communications may not be ensured when using this telephone.
To ensure safety of users, the FCC has established criteria for the amount of radio frequency 
energy that can be safely absorbed by a user or bystander according to the intended usage 
of the product. This product has been tested and found to comply with the FCC criteria. The 
handset may be safely held against the ear of the user. The telephone base shall be installed 
and used such that parts of the user’s body other than the hands are maintained at a distance 
of approximately 20cm (8 inches) or more.
This Class B digital apparatus complies with Canadian requirement: 
CAN ICES-3 (B)/NMB-3(B)