GE GFDS170GH-WW 설치 설명서

3

Keep flammable materials and vapors, such as gasoline, 

away from dryer.
Place dryer at least 18” (46 cm) above the floor for a 

garage installation.
Failure to do so can result in death, explosion, or fire.

•

 

Installation must conform to the 

MANUFACTURED HOME CONSTRUCTION AND 

SAFETY STANDARD, TITLE 24, PART 32–80 or 

Standard CAN/CSA-Z240 MH, or, when such 

standard is not applicable, with AMERICAN 

NATIONAL STANDARD FOR MOBILE HOME,  

ANSI/NFPA NO. 501B.

•

 

The dryer MUST be vented to the outdoors. The 

exhaust vent must be securely fastened to a 

non-combustible portion of the mobile home.

•

 

The vent MUST NOT be terminated beneath a 

mobile or manufactured home.

•

 

The vent duct material MUST BE METAL.

•

 

KIT 14-D346-33 MUST be used to attach the dryer 

securely to the structure.

•

 

The vent MUST NOT be connected to any other 

duct, vent or chimney.

•

 

Do not use sheet metal screws or other 

fastening devices which extend into the interior 

of the exhaust vent.

•

 

Provide an opening with a free area of at least 

25 square inches for introduction of outside air 

into the dryer room.

•

 

See the sections for electrical connection 

information. 

•

 

If the dryer is approved for installation in an 

alcove or closet, it will be stated on a label on the 

dryer back.

•

 

The dryer MUST be vented to the outdoors. See 

the EXHAUSTING THE DRYER section.

•

 

Minimum clearance between dryer cabinet and 

adjacent walls or other surfaces is:

    0” 

either 

side

    3” 

front

    3” 

rear

•

 

Minimum vertical space from dryer to overhead 

shelves, cabinets, ceilings, etc., is 1” on top.

•

 

Consideration must be given to provide adequate 

clearance for installation and service.

•

 

Closet doors must be louvered or otherwise 

ventilated and have at least 60 square inches 

(387 square cm) of open area. If the closet 

contains both a washer and a dryer, doors must 

contain a minimum of 120 square inches (774 

square cm) of open area.

NOTE:  WHEN THE EXHAUST DUCT IS LOCATED IN 

THE REAR OF THE DRYER, THE CONFIGURATION OF 

THE DUCTING MAY REQUIRE GREATER THAN 3” OF 

REAR CLEARANCE.

Gas Dryers Only:
•

 

No other fuel burning appliance shall be installed 

in the same closet as a gas dryer.

•

 

The dryer must be disconnected from the gas 

supply piping during pressure testing at pressures 

greater than ½ psi (3.5 kPa).

•

 

A 1/8 inch NPT minimum plugged tapping, 

accessible for test gauge connection, must be 

installed immediately upstream of the gas supply 

connection to the dryer.

Minimum clearance to combustible surfaces and 

for air opening are: 0” both sides, 1” front and 

3” rear. Consideration must be given to provide 

adequate clearance for installation and service.