Maytag MRT711BZDE 사용자 매뉴얼

On some models, your refrigerator's accessory packet includes 
an air filter, which must be installed prior to use. On some models, 
the air filter is already installed at the factory. 

The air filter reduces the buildup of odors. This helps to maintain a 
cleaner environment inside the refrigerator. 

The filter should be installed behind the vented door, which is 
located (depending on your model) along either the rear or left 
interior wall near the top of the refrigerator compartment.
1. Remove the air filter from its packaging.
2. Lift open the vented door.
3. Snap the filter into place.

The filter comes with a status indicator, which should be activated 
and installed at the same time the air filter is installed. 

1. Place the indicator face-down on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator, until 

the bubble pops to activate the indicator.

3. Lift open the vented air filter door. On some models, there are 

notches behind the door.
On models with notches:

■

Slide the indicator down into the notches, facing outward.

NOTE: The indicator will not easily slide into the notches 
if the rear bubble has not been popped.

■

Close the air filter door, and check that the indicator is 
visible through the rectangular hole in the door.

■

Store the indicator in a visible place you will easily 
remember - either inside the refrigerator, or elsewhere in 
your kitchen or home.

The disposable air filter should be replaced every 6 months. 
To order a replacement air filter, contact us using the 
assistance/service information following the warranty. 
1. Remove the old air filter by squeezing in on the side tabs.
2. Remove the old status indicator.
3. Install the new air filter and reset the status indicator using the 

instructions in the previous sections.

Your refrigerator has two controls that affect the temperature. The 
Temperature control is located at the top front of the refrigerator 
compartment, and the Airflow control is located on the back wall 
of the freezer compartment.
IMPORTANT: 

■

The recommended setting should be correct for normal 
household refrigerator use. The controls are set correctly 
when milk or juice is as cold as you like and when ice cream is 
firm.

■

Wait 24 hours for your refrigerator to cool completely before 
adding food. If you add food before the refrigerator has cooled 
completely, your food may spoil.

NOTE: Adjusting the refrigerator and freezer temperature 
controls to a colder than recommended setting will not cool 
the compartments any faster.

■

If the temperature is too warm or too cold in the refrigerator or 
freezer, first check the air vents to be sure they are not 
blocked before adjusting the controls.

For your convenience, the temperature control is preset at the 
factory. When you first install your refrigerator, make sure the 
control is still preset as shown.

■

Press and hold TEMP for 3 seconds to turn cooling off. To turn 
cooling back on, press and hold TEMP again for 3 seconds. 

NOTE: Neither compartment will cool when the control is set to 
OFF.   

If you need to adjust the temperature in either the refrigerator or 
freezer compartment, use the settings listed in the chart below as 
a guide.
NOTE: Except when starting the refrigerator, do not adjust the 
control more than one setting at a time. Wait 24 hours between 
adjustments for the temperature to stabilize. 

■

Press the TEMP button to toggle among the four LED lights 
which indicate the temperature setting. Reading from left to 
right, the LED in the first position is the least cold. The LEDs 
indicate increasingly colder settings as you continue to the 
right until all four LEDs are illuminated.