Marvel 15" Built-In Ice Maker - Black Cabinet & Overlay Door 사용자 설명서

The bin level sensor is located in the ice bin, it senses when the 

ice supply is low or full and starts or stops the ice making process 

accordingly.

If the water supply is turned off to the ice machine be sure to set 

the selector switch to the “OFF” position.

The ice machine will make sounds that are different than your 

household refrigerator. Because these sounds are new to you 

they may be of a concern but are most likely normal. Ice falling 

onto hard surfaces and water cascading across the evaporator 

will make sounds seem louder than they actually are. Following 

are some of the sounds that you may hear:

A buzzing sound will be heard when the water valve opens to 

fill the water reservoir.

You may hear a rattling noise which could be water flowing 

through the water line.

A splashing sound may be heard when water is flowing over 

the evaporator plate and into the water reservoir. 

When the ice slab is released from the evaporator plate you 

may hear a “thud” as it slides onto the grid cutter.

At the end of an ice making cycle you may hear a gurgling 

sound which is refrigerant flowing in the ice machine.

When the condenser fan turns on you might hear the air circu-

lating over the condenser.

1.  Avoid leaning on the cabinet door. You may bend the door 

hinge or tip the ice machine.

2.  Exercise caution when sweeping, vacuuming or mopping 

near the front of the ice machine. Damage to the grille and/

or switch can occur.

3.  Periodically clean the inside of the ice machine components 

and inside of the ice machine.

4.  If your ice machine has either a stainless steel door and/or 

cabinet, to keep it looking its best, we recommend periodi-

cally applying a stainless steel cleaner and a non-abrasive 

stainless steel polish. This is especially important for outdoor 

applications and locations near salt-water environments.

This build-up will need to be removed in the ice machine and 

stick to the ice machine’s parts over time. This build-up must be 

removed for proper ice production, ice quality, and ice machine 

life. Your ice machine is equipped with a cleaning mode that will 

help in cleaning out these impurities.

The impurities will need to be cleaned of this build-up regularly 

(at the very least, annually), depending on use and water hard-

ness. Use a nickel safe ice machine cleaner, including but not lim-

ited to the following brands. Ice machine cleaners are available 

at most appliance retailers or through the cleaner manufacturers 

web site.

     Kirby’s Certified ice machine cleaner, 100% nickel safe

     Nu-Calgon nickel safe ice machine cleaner

     Franklin Machine Products nickel safe ice machine cleaner  

 

1.  Switch the selector switch to the “OFF” position.

2.  Remove all the ice from the bin.

3.  Remove the front panel by removing the 2 screws. (See 

Figure 19).

Figure 19

Front

Panel

Front Panel

Screws

17

Your unit will produce ~ 30lbs of ice in a 24-hour period when 

installed in a 70°F ambient with a 55°F water supply. 

“Initial” ice production and ice accumulated in the storage bin 

will vary significantly.  This is normal.  During the first 24-hours of 

operation the unit will produce ~30lbs of ice at the above tem-

perature conditions, but when starting with an empty ice storage 

bin, the storage bin may only accumulate ~ 18lbs of ice.  By de-

sign, the ice storage bin is maintained at a temperature slightly 

above freezing to allow the stored ice to slowly melt, to preserve 

the clarity and assure a constant supply of fresh ice.  As ice is ac-

cumulated in the bin, the ice production rate will overcome the 

ice melt and the storage bin will fill to capacity.