Electrolux E48DF76EPS 설치 설명서
17
Installation
INSTALLING THE 30”, 36” & 48” RANGE OPTIONAL
BACKGUARDS
BACKGUARDS
Your Electrolux Icon
TM
range was shipped with a backguard in place. These
instructions cover the installation of one of the optional backguards.
Figure 11
Figure 12
Backguard Installation
(36” range shown)
Backguard Installation
(48” range shown)
NO
NO
NO
NO
NOTE
TE
TE
TE
TE
For 24” Backguards, fasten the provided screws through the holes in the back panel of
the Backguard.
the Backguard.
WARNING
WARNING
WARNING
WARNING
WARNING
Be sure that the range is not connected to gas or power before proceeding.
1. Remove the backguard from its box.
2. To avoid scratches, place small scraps of thin cardboard on the rear of
the side panels where the backguard will make contact. With the
assistance of at least one other person, carefully lift the backguard and
place down on to the range top. Special attention should be given to the
lower flange in front of the backguard, which must fit between the
stainless steel side panels.
assistance of at least one other person, carefully lift the backguard and
place down on to the range top. Special attention should be given to the
lower flange in front of the backguard, which must fit between the
stainless steel side panels.
3. Fasten the provided screws through the rear flange.
4. Connect the gas line to the regulator. Reposition and attach the access
panel or the back cover if the entire back cover was removed.
5. You are now ready to continue with the range installation.
Installing the Range Optional Backguard: