Electrolux E32AF75JPS 사용자 매뉴얼

If your freezer has an automatic icemaker, it will 
provide a suffi cient supply of ice for normal use. 
During the initial startup of your freezer, however, 
no ice will be produced during the fi rst 24 hours of 
operation.  Automatic ice makers are also optional 
accessories that may be installed in some models at 
any time.  Call your local dealer for information.

After the plumbing connections have been completed, 
the water supply valve must be opened.  Place the ice 
container under the ice maker, pushing it as far back 
as possible.  Lower the wire signal arm to its “down” or 
ON position.  New plumbing connections may cause 
the fi rst production of ice cubes to be discolored or 
have an odd fl avor.  These fi rst cubes should be
discarded until the cubes produced are free of 
discoloration and taste.

To stop the ice maker, lift the wire signal arm until 
it clicks and locks in the “up” or OFF position.  The 
ice maker also turns off automatically when the ice 
container is full.  If your model has an adjustable 
freezer shelf, place the shelf in the lower position,
so that the wire signal arm will hit the ice when the 
container is full.

•   If the ice maker will be turned off for a long period 

of time, turn the water supply valve to the closed 
position.

•   Ice cubes stored too long may develop an odd 

fl avor.  Empty the ice container and ensure that 
the wire signal arm is in its “down” or ON position. 
The ice maker will then produce more ice.

•   Occasionally shake the ice container to keep ice 

separated.

•   Keep the wire signal arm in its “up” or OFF 

position until the freezer is connected to the water 
supply or whenever the water supply is turned off.

•   The following sounds are normal when the ice 

maker is operating:

 

•   Motor running

 

•   Ice loosening from tray

 

•   Ice dropping into ice container

 

•   Running water

 

•   Water valve opening or closing

Your ice maker is shipped with the wire signal arm in 
the ON position.  To ensure proper function of your 
ice maker, hook up water supply immediately or turn 
ice maker OFF by lifting the wire signal arm until it 
clicks and locks in the UP position.

Check the leveling bracket on the ice maker to ensure 
the ice maker is level.  If the gap between the freezer 
wall and the ice maker is the same at top and bottom, 
then ice maker is level.  If the ice maker is not level, 
loosen the screw and slide the bracket to the correct 
position to make it level.  Retighten the screw.  You 
will need a 1/4 inch socket wrench for this task.