John Deere 100 Series 사용자 설명서
Service Lubrication - 24
SERVICE LUBRICATION
• Lubricate front axle pivot.
• Lubricate front axle wheel spindles and bushings.
Every 25 Hours
• Lubricate mower spindles.
• Lubricate mower pivot points.
• Lubricate front axle pivot.
• Lubricate front axle wheel spindles and bushings.
Every 50 Hours
• Change engine oil and replace filter. (Service more frequently under
dusty conditions.)
dusty conditions.)
• Clean/replace air filter precleaner. (Service more frequently under dusty
conditions.)
conditions.)
• Replace air filter element. (Service more frequently under dusty
conditions.)
conditions.)
• Clean/replace emission filter (if equipped).
• Clean engine cooling fins.
• Replace fuel filter.
• Replace spark plug(s).
• Clean battery terminals.
• Sharpen/replace mower blades.
• Check/replace mower drive belt.
• Clean mower deck.
• Check/level mower deck.
• On 107 cm (42 in.) deck: Check/adjust mower deck belt tension.
• On 107 cm (42 in.) deck: Check/adjust mower deck spindle brakes.
Every 200 Hours
• Check/adjust valve clearance. See your John Deere dealer for this
service.
service.
Service Lubrication
Grease
The following greases are preferred:
• John Deere Multi-Purpose SD Polyurea Grease
• John Deere Multi-Purpose HD Lithium Complex Grease
If not using any of the preferred greases, be sure to use a general all-
purpose grease with an NLGI grade No.2 rating.
purpose grease with an NLGI grade No.2 rating.
Wet or high speed conditions may require use of a special-use grease.
Contact your Servicing dealer for information.
Contact your Servicing dealer for information.
Lubricating Front Axle
MX16565
Wheel Spindles and Bushings
• Lubricate front wheel spindle grease fitting (A) and wheel hub grease
fitting (B), one on each side, with one or two shots of general all-purpose
grease.
fitting (B), one on each side, with one or two shots of general all-purpose
grease.
Front Axle Pivot
• Lubricate front axle center pivot grease fitting (C) with one or two shots of
general all-purpose grease.
general all-purpose grease.
Lubricating Pivot Points
107 cm (42 in.) Mower Deck:
MX25899
A- Blade Brake Pivots
B- Deck Idler Pivot
C- Spindle Grease Fitting (2)
• Lubricate the blade brake pivots (A) and deck idler pivot (B) with a
general all-purpose spray lubricant.
general all-purpose spray lubricant.
• Lubricate the two spindle grease fittings (C) with one or two shots of
general all-purpose grease.
general all-purpose grease.
IMPORTANT: Avoid damage! Use recommended John Deere
greases to avoid component failure and premature wear.
greases to avoid component failure and premature wear.
The recommended John Deere greases are effective within an
average air temperature range of -29 to 135 degrees C (-20 to 275
degrees F).
average air temperature range of -29 to 135 degrees C (-20 to 275
degrees F).
If operating outside that temperature range, contact your
Servicing dealer for a special-use grease.
Servicing dealer for a special-use grease.
C
A
B
A
B
C
C