Zebra Technologies RW 220 사용자 설명서

 12 

RW 220 Vehicle Cradle Installation Guide

from the charger jack.

•  Press the latch release button on the Vehicle Cradle and pivot 

the Printer out of the Cradle.

Loading Media

Follow the loading procedures found in the RW Series Users 

Guide.

Printer Access

The media compartment and operator controls can be reached 

while the printer is secured in the Vehicle Cradle.

If you need to remove the printer for servicing follow the printer 

removal procedure detailed above.

Connections to a Terminal
Communications with a Terminal

If you are also installing a terminal in the vehicle, consult the ter-

minal manufacturer’s literature for installation instructions. If the 
terminal and Printer will communicate using either an RS232 or 
USB cable, use shielded cables and keep their length as short as 
possible. Ensure the routing of the cable does not invite damage to 
the cable or interfere with the control or use of the vehicle.

If you are communicating by means of a USB or RS232C cable, 

you must use a Zebra communications cable designed for use with 
your terminal. 

Consult your Zebra Sales Representative or re-seller for informa-

tion on the various I/O data cables offered by Zebra for use with a 
variety of widely used terminals.

If the terminal and the Printer will communicate via an RF link, it 

is the installer’s responsibility to test the strength and reliability of 
such a link prior to final installation.

Power Connections to a Terminal

If you are also installing a terminal in the vehicle, you must run 

two separate cables from the vehicle power source: one to the 
printer and one to the terminal. 

The terminal power cable must be either supplied by the terminal 

manufacturer or fabricated by the installer.

It is the installer’s responsibility to determine the suitability of 

running a terminal from the vehicle’s battery.