VeriFone 1000SE 사용자 설명서
S
ETUP
Use Stand Adapter
PIN
PAD
1000SE I
NSTALLATION
G
UIDE
13
1
Disconnect power from the PC/AT.
2
Connect the end of the cord with the DB25/DB9 connector to the PC/AT.
3
Connect the modular plug on the other end of the cord to the PINpad 1000
SE
device.
4
Plug the power supply cord into the socket at the base of the PC/AT
connector.
5
Plug the power supply into an AC wall outlet.
6
Reconnect power to the PC/AT.
Use Stand
Adapter
The optional stand adapter holds the PINpad 1000
SE
unit securely to a countertop
or a wall. The unit can be removed from the stand adapter anytime for handheld
operation.
operation.
Mounting the
Adapter to Plate
plate.
1
Select a location for the stand adapter on a smooth wall or countertop. Be
sure the cable can easily reach the controller from this position without
stretching.
stretching.
2
Position the keyholes on the molded cradle over the slotted screws on
mounting plate. Slide the adapter downward until the screws are in the narrow
ends of the keyholes.
ends of the keyholes.
Figure 5
Stand Adapter Installation
CAUTION
Using an incorrectly rated power supply can damage the unit or cause it not to
work properly. VeriFone recommends using only VFN# CPS04951-xx but
supports VFN# CPS11220-3A if used with a country-specific power cord (see
supports VFN# CPS11220-3A if used with a country-specific power cord (see
for detailed power supply specifications).