DELL H200 사용자 설명서

Driver Installation

3 Press the <S> key.

The system prompts for the driver media to be inserted.

NOTE:

The driver can be provided using a properly formatted USB key.

Check the Dell Support website at

support.dell.com

for additional details.

4 Insert the driver media in the media drive and press <Enter>.

A list of SAS controllers appears.

5 Select the right driver for the installed controller and press <Enter> to

load the driver.

NOTE:

For Windows Server 2003, a message can appear that states that the

driver that you provided is older or newer than the existing Windows driver.
Press <S> to use the driver that is on the media.

6 Press <Enter> again to continue the installation process as usual.

Installing the Driver During a Windows Server 2008 or Windows Server
2008 R2 Installation

Perform the following steps to install the driver during operating system
installation.

1 Boot the system using the Windows Server 2008 or the Windows Server

2008 R2 media.

2 Follow on-screen instructions until you reach the message Where do you

want to install 7/2008; then select Load driver...

3 The system prompts for the media to be inserted. Insert the installation

media and browse to the proper location when prompted.

4 Select the appropriate PERC H200 card from the list, click Next and

continue installation as usual.

NOTE:

The Windows Server 2008 R2 operating system includes native support for

the PERC H200 card. The driver is automatically installed. For driver updates, see
the Dell Support website at support.dell.com.

PERC H200.book Page 34 Tuesday, July 13, 2010 4:15 PM