3com WX1200 3CRWX120695A 사용자 설명서

cipher-ccmp

disable

Does not use Counter with Cipher Block 
Chaining Message Authentication Code 
Protocol (CCMP) to encrypt traffic sent to 
WPA clients.

cipher-tkip

enable

When the WPA IE is enabled, uses 
Temporal Key Integrity Protocol (TKIP) to 
encrypt traffic sent to WPA clients.

cipher-wep104

disable

Does not use Wired Equivalent Privacy 
(WEP) with 104-bit keys to encrypt traffic 
sent to WPA clients.

cipher-wep40

disable

Does not use WEP with 40-bit keys to 
encrypt traffic sent to WPA clients.

cos

0

If static CoS is enabled (static-cos is set to 
enable), assigns CoS 0 to all data traffic 
to or from clients. 

dhcp-restrict

disable

Does not restrict a client’s traffic to only 
DHCP traffic while the client is being 
authenticated and authorized. 

idle-client-probing

enable

Sends a keepalive packet (a null-data 
frame) to each client every 10 seconds.

long-retry-count

5

Sends a long unicast frame up to five 
times without acknowledgment.

no-broadcast

disable

Does not reduce wireless broadcast traffic 
by sending unicasts to clients for ARP 
requests, DHCP Offers, and Acks instead 
of forwarding them as multicasts.

proxy-arp

disable

Does not reply on behalf of wireless 
clients to ARP requests for client IP 
addresses. Instead, the radio forwards the 
ARP Requests as wireless broadcasts.

psk-phrase

No passphrase 
defined

Uses dynamically generated keys rather 
than statically configured keys to 
authenticate WPA clients.

psk-raw

No preshared 
key defined

Uses dynamically generated keys rather 
than statically configured keys to 
authenticate WPA clients.

rsn-ie

disable

Does not use the RSN IE in transmitted 
frames.

Table 73   Defaults for Service Profile Parameters (continued)