Nexgrill 720-0050-LP 사용자 설명서

 

When I light the grill it does not flame 

immediately.  

--Make sure you have turn on the gas   

--Make sure it has spark while you are trying to 

ignite the burner. 

--Push in for approximately 5 second before to turn 

and ignite the grill. 

--Make sure your burner is clean. 

Rotisseries burner will not light when 

the igniter button is pushed.   

--Check to see if debris is blocking the      electrode 

sparks. 

--Check to see there is spark that jumps to the 

burner from the electrode wire. If no spark is 

seen. 

--Check the battery located inside the button. Press 

and turn counter clockwise. 

--Check for loose wire connection. 

--Gently bend the electrode wire closer to the 

burner until a spark is seen to jump from the 

igniter to the burner when you press the starter 

button. 

--Dose the infrared back burner light when 

attempting to match light? If not, check did you 

turn on the gas. 

Regulator makes noise. 

--Vent hose on the regulator may be plugged or 

regulator may be faulty. 

--Ensure the vent hole on the regulator is not 

obstructed. Clear the hole, close the LP tank and 

gas control valves. Wait ten minutes and re-start. 

--When turning the LP tank valve on, do not cover 

vent hole on the regulator. 

--Check your flames for proper performance if the 

flames are not correct replace regulator. 

Full size cover does not fit the grill. 

--Cover may be incorrect for your grill. It may be a 

tight fit. Ensure the cover correct length for your 

grill. Measure it left to right. Compare to the grill’s 

measurement. 

--Compare the location and size of the hood portion 

of the cover to your grill. 

--Spread the cover and allow it to relax, preferably 

in warm sunlight or in a warm room.