Frigidaire A01060901 사용자 매뉴얼

14

If your freezer has an automatic icemaker, it will 

provide a sufficient supply of ice for normal use. 

During the initial startup of your freezer, however, 

no ice will be produced during the first 24 hours 

of operation.
Automatic ice makers are also optional 

accessories that may be installed in some models 

at any time. Call your local dealer for information.

After the plumbing connections have been 

completed, the water supply valve must be 

opened. Place the ice container under the ice 

maker, pushing it as far back as possible. Lower 

the wire signal arm to its “down” or ON position. 

New plumbing connections may cause the first 

production of ice cubes to be discolored or 

have an odd flavor. These first cubes should be 

discarded until the cubes produced are free of 

discoloration and taste.

To stop the ice maker, lift the wire signal arm until 

it clicks and locks in the “up” or OFF position. The 

ice maker also turns off automatically when the ice 

container is full. If your model has an adjustable 

freezer shelf, place the shelf in the lower position, 

so that the wire signal arm will hit the ice when 

the container is full.

•  If the ice maker will be turned off for a long 

period of time, turn the water supply valve 

to the closed position.

•  Ice cubes stored too long may develop an 

odd flavor. Empty the ice container and 

ensure that the wire signal arm is in its 

“down” or ON position. The ice maker will 

then produce more ice.

•  Occasionally shake the ice container to keep 

ice separated.

•  Keep the wire signal arm in its “up” or OFF 

position until the freezer is connected to the 

water supply or whenever the water supply 

is turned off.

•  The following sounds are normal when the 

ice maker is operating:

 

• Motor running

 

• Ice loosening from tray

 

• Ice dropping into ice container

 

• Running water

 

• Water valve opening or closing

Wire

Signal Arm

Ice

Container

Leveling Bracket

Your ice maker is shipped with the wire signal 

arm in the ON position. To ensure proper 

function of your ice maker, hook up water 

supply immediately or turn ice maker OFF by 

lifting the wire signal arm until it clicks and 

locks in the UP position.
Check the leveling bracket on the ice maker to 

ensure the ice maker is level. If the gap between 

the freezer wall and the ice maker is the same 

at top and bottom, then ice maker is level. If 

the ice maker is not level, loosen the screw and 

slide the bracket to the correct position to make 

it level. Retighten the screw. You will need a ¼ 

inch socket wrench for this task.

•  DO NOT place the ice container in dishwasher.
•  Wash the ice container in warm water with 

mild detergent. Rinse well and dry.

•  Stop the ice maker when cleaning the 

freezer and during vacations.