Kobe Range Hoods CH0136SQB 사용자 설명서

UNDER THE CABINET INSTALLATION

Preparation Before Installation

NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT

DEBRIS

FROM

ENTERING

THE

VENT

OPENING.

•

Decide the location of the venting pipe from the hood to

the outside. Refer to Figure 1.

•

A straight, short vent run will allow the hood to

perform more efficiently.

•

Try to avoid as many transitions, elbows, and long runs

as possible. This may reduce the performance of the
hood.

•

Temporarily wire the hood to test for proper

operation before installing.

•

NOTE: Peel protective film off the hood and parts (if

any).

•

To install hood under a cabinet with recessed

bottom, attach 4-inch wide wood filler strips (not
included) on each side. Refer to Figure 2.

•

Using references in Table 1 and Measurements and

Diagrams on pages 17-18, create access opening for
electrical wires and ducting transition under the
cabinet.

Hood Installation

CAUTION: If moving the cooking range is necessary

to install the hood, turn off the power in an electric
range at the main electrical box. SHUT OFF THE GAS
BEFORE MOVING A GAS RANGE.

1. Puncture the knockout holes (for mounting under the

cabinet) on the hood as shown in Figure 3.

2. Attach ducting transition to hood exhaust with ten

(3/16” x 3/8”) screws (provided). Shown in Figure 4.

3. Draw electrical wires through cabinet access opening.

4. Center the hood beneath the cabinet and flush with the

front of the cabinet.

5. From the bottom of the hood, place mounting screw

(not  provided)  through  each  knockout  hole  and  secure
to  cabinet  bottom.    Once  all  mounting  screws  are  in
place,  finish  tightening  screws  until  secure.  CAUTION:
MAKE

SURE

HOOD

SECURE

BEFORE

RELEASING.

6. For safety purpose, extra knockout holes on the back of

the hood are provided for a more secure installation.
Knock out as many holes as needed and secure with
screws (not provided) from the inside of hood.

Figure 1

Figure 2

Figure 3

Figure 4