Maytag RFS 사용자 설명서

To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors before
following any disassembly procedure.

28

16023293   Rev. 0

©2004 Maytag Services

replaced.

Adjusting Interlocks
The interlock monitor, primary, and secondary switches
act as a final safety switch, protecting the operator from
microwave energy. After adjusting the interlock switch
assembly, verify wires are correctly connected.

For door fit and switch operation, switch bracket is
adjustable.

1. Disconnect power to oven and remove outer case,

(see "Outer Case" procedure).

2. Loosen switch bracket mounting screws.
3. Close oven door, move switch bracket toward rear of

oven until door gap is less than 

1

/

64

–inch (0.5 mm).

4. Hold switch bracket securely for proper switch

operation and door fit, retighten screws.

5. Open oven door slowly, watching the switches. Verify

switches release in the following order.
• Primary interlock switch
• Secondary interlock switch
• Interlock monitor switch

NOTE: Adjust the switch bracket until all switches

operate in proper sequence.

6. Close the oven door slowly, watching the switches.

Verify switches activate in the following order.
• Interlock monitor switch
• Secondary interlock switch
• Primary interlock switch

7. When proper switch sequence has been achieved,

tighten the switch bracket securely.

A microwave leakage test must be preformed anytime
a door assembly is removed, replaced, disassembled,

or adjustment of switch bracket is performed.

High voltage capacitor should always be discharged by
shorting a terminal to a chassis ground.  The capacitor
has a internal "shunt" resistor, but the mechanical
discharge should always be performed to avoid personal
injury.

High Voltage Capacitor Removal
1. Disconnect power to oven and remove outer case,

(see "Outer Case" procedure).

2. Discharge high voltage capacitor.
3. Remove and label wire leads from capacitor terminals.
4. Remove screw securing capacitor strap to bottom

plate.

5. Slide capacitor out of capacitor strap and remove

capacitor.

6. Replace capacitor and reverse procedure to

reassemble.

NOTE: When replacing H.V. components, route H.V.

wires at least 

1

/

4

" / 6 mm from all grounded

surfaces to prevent arcing.

H.V. Capacitor

Bracket

H.V. 

Capacitor

H.V. 

Diode

H.V. 

Transformer

Bottom

Plate

Blower Motor

Assembly

1. Disconnect power to oven and remove outer case,

(see "Outer Case" procedure).

2. Discharge high voltage capacitor, (see "High Voltage

Capacitor" section).

3. Disconnect diode from high voltage capacitor and

remove screw securing diode to ground.