Maytag RFS 사용자 설명서

To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors before
following any disassembly procedure.

©2004 Maytag Services

16023293   Rev. 0

31

1. Disconnect power to oven and remove outer case,

(see "Outer Case" procedure).

2. Remove outer case.
3. Remove TCO by removing screws.
4. Disconnect wiring.
5. Replace component and reverse procedure to

reassemble.

NOTE: When reconnecting wiring to thermal fuses the

connectors must be tight.

1. Disconnect power to oven and remove outer case,

(see "Outer Case" procedure).

2. Remove outer case.
3. Remove thermal fuse mounting screw.
4. Disconnect wiring.
5. Replace component and reverse procedure to

reassemble.

NOTE: When reconnecting wiring to thermal fuses the

connectors must be tight.

1. Unplug oven from outlet.
2. Using a suction cup to pry upward on front portion and

remove tray from unit.

3. Thoroughly clean and degrease sump area.
4. Clean oven cavity bottom where new oven tray will

make contact using mineral spirits or any
non-flammable degreasing solvent.

NOTE: Detergents, soap, and water are not sufficient to

remove oil and grease.

5. Place new tray into unit and clean cavity with mild

detergent to remove any remaining degreasing
solvant.

The light bulb for inside of the oven can be changed only
from the side of the unit. On the left hand side of the oven
is a metal plate with one screw.  The light bulb is located
behind this plate.

Follow these steps to change the bulb:
1. Disconnect power to oven and remove outer case,

(see "Outer Case" procedure).

2. Remove screw and plate from side of unit.
3. To remove bulb, turn it counterclockwise, being

careful not to burn fingers or break the bulb.

4. Replace bulb with a 40 watt, 115 - 125 volt appliance

bulb.

5. Reposition plate, being careful not to bend hinge tab.

Replace and tighten screw. Do not operate oven
without plate in place.