Beko TFF546APS 사용자 설명서

EN

7

 

1. The space in the room where the

 appliance is installed must not be

smaller than 10 cubic metres.

 

2. If possible avoid placing the

 appliance near cookers, radiators or
 in direct sunlight as this will cause the
 compressor to run for long periods.
 If installed next to a source of heat
 or refrigerator, maintain the following

minimum side clearances:

  2”   (50 mm)

      From Cookers  

12” (300 mm)

      From Radiators  

          From Refrigerators or Freezers

1”   (25 mm)

 

3. Make sure that sufficient room

 is provided around the appliance
 to ensure free  air circulation. Allow
 a minimum of 60 mm (2.4 inches)
 between the top of the appliance and
 the ceiling or the underside of a wall

cupboard.

 

4. Fit the two plastic wall spacers

 supplied onto the condenser at the
 back of the appliance by rotating them

1/4 turn.

 

5. The appliance should be located on

 a smooth surface.

 The two front feet can be adjusted as
 required.
 To ensure that,your appliance is
 standing upright adjust the two front

feet by turning clockwise or anti-

 clockwise, until the product is in
 firm contact with the floor. Correct
 adjustment of feet avoids excessive

vibration and noise.

 

6. Refer to “Cleaning and Care”

 section to prepare your appliance for

use.

 

7.A special receptacle is supplied to

 store the mains plug during transit.
 The receptacle is fixed at the back of
 the cabinet, on the right hand side of
 the compressor. (See diagram) Gently
 remove the plug from the receptacle.
 Never pull the mains cord, you may
 damage the appliance. In the case
 of transportation, ensure you locate
 the plug in the receptacle provided to
 avoid transit damage. transit

.provided to avoid transit damage

  The appliance must be protected

 against rain, moisture and other

atmospheric influences.