Bostitch BTFP12180 사용자 설명서

다운로드
페이지 13
ADJUSTING THE BTFP12180/BTFP12181
STAPLE SELECTOR (ALL MODELS) (FIG 1)
To adjust the tool for different leg lengths, loosen set-screw (A) and turn dial 180° (B) with a screwdriver 
to the desired position as noted in the tables at the front of this manual. Tighten set-screw.
LOADING THE TOOL - BTFP12180/BTFP12181
A)
Pull the pusher to the back of the magazine. (Fig 2)
B)
Check Staple Leg Length: Adjustment is provided for 
different staple leg lengths (see section below).
C)
Insert 2 sticks of staples into the channel and gently 
release the pusher against the staples. (Fig 3)
CLINCH ADJUSTMENT - BTFP12180/BTFP12181 (FIG 4)
Turn special nut (A) through window clockwise to tighten clinch 
and counter-clockwise to loosen clinch. Use a tool to fit 1/8” (3mm) 
LOADING THE BTFP12180/BTFP12181
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool.  Eye  protection  is  required  to  guard  against  flying  fasteners  and  debris,  which  could
cause severe eye injury.
The  employer  and/or  user  must  ensure  that  proper  eye  protection  is  worn.  Eye  protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI  Z87.1  and  provide  both  frontal  and  side  protection.  NOTE:    Non-side  shielded
spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in discharge area of tool while 
the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull or depress the actuating lever unless nose is directed at the work.
• Always handle the tool with care.
• Do not depress the actuating lever while loading the tool.
TOOL ADJUSTMENT CHART
FIG.4
-4-
S
L
S
L
5/8" (15mm)
3/4" (19mm)
STAPLE
LENGTHS
DIAL
POSITION
FIG.1
FIG.2
FIG.3
A
B