Windsor 10023090 사용자 설명서
MAINTENANCE
LIGHTNING 86039180 05/23/07
4-2
INSTALLING OR REMOVING PAD
DRIVER OR PADS
DRIVER OR PADS
Consult an authorized distributor to assist you in
selecting the correct pad for your specific needs.
selecting the correct pad for your specific needs.
Pad driver installation:
1. Tip machine on the right side (dip stick down).
2. Place pad driver on drive shaft and spin pad
2. Place pad driver on drive shaft and spin pad
driver clockwise to install.
Pad Removal & Installation:
1. Tilt machine back on rear caster or service
position.
2. Remove center-lock from pad driver.
3. Remove pad from pad holder.
4. Center new pad on pad driver & secure with
center-lock ring.
Pad driver removal:
1. Apply down pressure on bell of machine deck.
2. Use ¾” open end wrench on top of drive shaft
exposed on top of deck.
3. Strike wrench with rubber mallet to break loose
the shaft from the pad driver. (counter-clockwise)
4. Remove pad driver by spinning it off counter-
2. Use ¾” open end wrench on top of drive shaft
exposed on top of deck.
3. Strike wrench with rubber mallet to break loose
the shaft from the pad driver. (counter-clockwise)
4. Remove pad driver by spinning it off counter-
clockwise.