Uniden UBCT9 사용자 설명서

•   Turn the scanner OFF before disconnecting the power.

•   Always write down the programmed frequencies in the event of memory loss.

•   If memory is lost, simply reprogram each channel.
 

The display shows 000.0000 in all channels when there has been a memory loss.

•   Do not use the scanner in high-moisture environments such as the kitchen or bathroom.

•   Avoid placing the unit in direct sunlight or near heating elements or vents.

•   If the scanner receives strong interference or electrical noise, move it or its antenna
 

away from the source of the noise. If possible, a higher elevation may provide better

 

reception.

•   Disconnect the power to the unit before cleaning.

•   Clean the outside of the scanner with a mild detergent.
 

To prevent scratches, do not use abrasive cleaners or solvents. Be careful not to rub     

 

the LCD window.

•   Do not use excessive amounts of water.

•   Do not attempt any repair. The scanner contains no user serviceable parts contact your
 

retailer or see warranty page for service information.

•   All radios can receive birdies (undesired signals). If your scanner stops during Scan
 

mode and no sound is heard, it may be receiving a birdie. Birdies are internally

 

generated signals inherent in the electronics of the receiver.

Press L/O to lockout the channel, and then press HOLD/RESUME to resume scanning.

UBCT9 OM   52

12/11/07   3:54:04 PM