Netgear M4100-12GF 사용자 설명서

Network Interface Commands

This section describes the commands you use to configure a logical interface for 
management access. To configure the management VLAN, see 

Use this command to access the Privileged EXEC mode. From the Privileged EXEC mode, 
you can configure the network interface.

enable

Use this command to set the IP address, subnet mask, and gateway of the device. The IP 
address and the gateway must be on the same subnet.

network parms <ipaddr> <netmask> [<gateway>] 

Use this command to specify the network configuration protocol to be used. If you modify this 
value, change is effective immediately. If you use the bootp parameter, the switch 
periodically sends requests to a BootP server until a response is received. If you use the 
dhcp

 parameter, the switch periodically sends requests to a DHCP server until a response is 

received. If you use the none parameter, you must configure the network information for the 
switch manually.

network protocol {none | bootp | dhcp}

Use this command to set locally administered MAC addresses. The following rules apply:

Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally 

administered (b'0') or locally administered (b'1'). 

Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual 

address (b'0') or a group address (b'1'). 

The second character, of the twelve character macaddr, must be 2, 6, A or E.

User EXEC

Privileged EXEC

none

Privileged EXEC