Avaya P460 사용자 설명서

Chapter 2 

Establishing Switch Access 

In order to... 

Use the following command... 

Send an ICMP echo request packets 
to another node on the network. 

For more detailed information on the CLI commands, please refer to the 

Establishing a Telnet Connection with the Switch (Outband) 

Perform the following steps to establish a Telnet connection to the P460 for 
configuration: 
L  You need to assign an outband interface IP address using a direct connection to 

the console serial port before you can establish the Telnet session. 

L  You can configure the Fast Ethernet console port parameters if necessary. 
L  The outband interface should be on a different subnet from the inband interface. 
1 

Connect your station to the Fast Ethernet console port (directly or via the 
network). 

2 

Verify that you can communicate with the P460 using “ping” to the outband 
interface IP of the P460. If there is no response using the Ping command, check 
the IP address and default gateway of both the P460 and the station. 

3 

Start a Telnet session: 

—  From the Microsoft Windows

®

 taskbar of your PC click Start and then Run 

or access the command prompt 

—  Start the Telnet session by typing: telnet <P460_IP_address> 

For example: telnet 149.49.35.214 

X  The Login Name prompt is displayed 
4 

Enter the default name root 

X  The password prompt is displayed 
5 

Enter the password root in lower case letters. 

L  You can now configure the P460. 
L  You can connect the Out-band interface to either of the Supervisor modules. 

Avaya P460 

Configuration Guide 

5