Avaya P460 사용자 설명서

다운로드
페이지 86
Chapter 4 
Avaya P460 Layer 2 Features 
CAM Table€
It might be inefficient if the Avaya P460 could not “remember” which MAC address 
was accessible from which port, that is, where a specific device is attached. 
Therefore, the P460 stores a mapping of learned MAC addresses to port and VLANs 
in the CAM table. The switch then checks subsequent frames. If the MAC address 
appears in the CAM Table, then the packet is forwarded to the appropriate port. 
If the MAC address does not appear in the CAM table, or the MAC Address 
mapping has changed, then the frame is duplicated and copied to all the ports. Once 
a reply is received, the CAM table is updated with the new address/VLAN port 
mapping. 
The CAM table size in the Avaya P460 is a minimum of 4k and a maximum of 8k. 
Ethernet Configuration CLI Commands 
In order to... 
Use the following command... 
Set the auto negotiation mode of a 
port 
set port negotiation 
Administratively enable a port 
Administratively disable a port 
Set the speed for a 10/100 port 
Configure the duplex mode of a 
10/100BASE-T port 
Configure a name for a port 
Set the send/receive mode for flow-
control frames on a full duplex port 
Set the flow control advertisement 
for a Gigabit port when performing 
autonegotiation 
Display settings and status for all 
ports 
Display per-port status information 
related to flow control 
Display the flow control 
advertisement for a Gigabit port 
used to perform auto-negotiation 
Avaya P460 Configuration Guide 
17